Connectors; Dip Switches; Configuration Button; Leds - SolarEdge Home Gateway Installation Manual

Chapter 2: Home Gateway User Interfaces

Connectors


USB: Connection to the power supply. This port can also be
used for connecting to a computer for advanced configuration
or SW upgrade.

Ethernet: Connecting the SolarEdge gateway to the SolarEdge
monitoring portal through an Ethernet switch/router. The
Ethernet switch/router should be connected to the Internet.

DIP Switches

Two DIP switches are located at the side of the gateway. They are
used for internal configuration; therefore, their position should not
be changed.

Configuration Button

The configuration button is used for the following:

Discovery of slave devices and associating them to the home
gateway

Diagnosis of communication problems
►
To use the configuration button:

Short press: Pressing the configuration button for 5-10
seconds and releasing it - discover slaves (device
discovery)

Long press: Pressing the configuration button for more
than 10 seconds and releasing it - start diagnostics mode
(refer to Appendix A: Troubleshooting on page 18.

LEDs

The gateway has four LED indicators, as follows:
12
Home Gateway Installation Guide – MAN-01-00118-1.4