Trip Computer /Vehicle Parameters P - PEUGEOT nüvi 205 Owner's Manual

10 TRIP COMPUTER/VEHICLE PARAMETERS
TRIP COMPUTER
1
Press the MAIN button or press
the MODE button several times in
succession until the trip computer is
displayed.
- The "vehicle" tab:
The range, the current fuel
consumption and the distance
remaining.
- The "1" (trip 1) tab with:
The average speed, the average
fuel consumption and the distance
travelled calculated over route "1".
- The "2" (trip 2) tab with the same
functions for a second route.
Each press of the button at the end of the wiper stalk displays the
different trip computer information in succession, according to the
screen.
264
AP_3008_01_2010_anglais_cag_pdf_264 264 AP_3008_01_2010_anglais_cag_pdf_264 264
A FEW DEFINITIONS
Range: displays the distance which can travelled with the remaining
fuel detected in the tank, basd on the average consumption over the
last few miles (kilometres).
This displayed value may vary signi cantly following a change in the
vehicle speed or the relief of the route.
When the range falls below 20 miles (30 km), dashes are displayed.
After lling with at least 5 litres of fuel, the range is recalculated and
is displayed when it exceeds 60 miles (100 km).
If, whilst driving, dashes are displayed continuously in place of the
digits, contact a PEUGEOT dealer.
Current fuel consumption: only calculated and displayed above
20 mph (30 km/h).
Average fuel consumption: this is the average fuel consumption
since the last trip computer zero reset.
Distance travelled: calculated since the last trip computer zero reset.
Distance remaining to the destination: calculated with reference
to the nal destination, entered by the user. If guidance is activated,
the navigation system calculates it as a current value.
Average speed: this is the average speed calculated since the last
trip computer zero reset (ignition on).
04/02/2010 14:32:26 04/02/2010 14:32:26