Advertisement
16 channel EHV shown
CH1
CH2
CH3
CH4
CH5
CH6
CH9
CH10
CH11
CH12
CH13
CH14
QUICK INSTALLATION
1.
Connect cameras to video inputs, and if using, connect PTZ camera control
lines to RS485 connector.
2.
Connect the main monitor to the VGA monitor output or
main video output - MAIN OUT.
3.
Connect analog monitors to looping video outputs. (optional)
4.
Connect the monitor to the SPOT video output. (optional)
5.
Connect sensors to alarm signal inputs. (optional)
RS485
R
R
T
T
1
2
3
4
5
6
7
8
G
9 10 11 12 13 14 15 16
X
X
X
X
N
-
-
SENSOR
CH7
CH8
+
+
D
AUDIO IN
IN1
IN3
MAIN OUT
AUDIO
OUT
RS-232
IN2
IN4
CH15
CH16
SPOTOUT
VGA
6.
Connect alarm devices such as buzzers to alarm signal outputs. (optional)
7.
Connect a speaker and microphone to the audio input and output. (optional)
8.
Connect a network cable to the network port.
9.
Power on all the connected equipment.
10.
Connect the power cord to the DVR.
11.
Add network cameras. (optional)
©2012 Surveillix DVR Support Center All rights reserved. All products and names mentioned are the property of
their respective owners. While Surveillix has made every effort at the time of publication to ensure the accuracy of
the information provided herein, product specifications, configurations, prices, system components, and options
availability are all subject to change without notice.
EXTERNAL
SATA DRIVE
SERIAL
OUTPUT
G
1P 1N 2P 2N 3P 3N 4P 4N
PAL
NTSC
N
SENSOR
ALARM OUT
D
LAN
POWER
USB
12V
5A max
IP CAMERAS
MOUSE
CONFIGURING THE RECORDER
When you start the EHV recorder for the first time, you need to configure the system settings to
match your location and time and ensure proper indexing of your recorded video. Go to
SETUP > SYSTEM CONFIGURATION to adjust the following settings:
VIDEO FORMAT: NTSC/PAL
DATE FORMAT: ASIA (YYYY/MM/DD), US (MM/DD/YYYY) and EURO (DD/MM/YYYY).
DATE: Specify the current date.
TIME: Specify the current time.
TIME ZONE: Set the local time zone.
USE DST: Select to use DST(Daylight Saving Time), turn on this toggle option.
HOW TO USE IR REMOTE CONTROLLER
When more than one EHV DVR is installed in the same location, use one remote controller to
control multiple DVRs. To control multiple DVRs, you must change the remote controller ID to
match the DVR ID of the DVR.
Follow the instructions below to change the remote controller ID.
On the DVR
1.
Go to SYSTEM > SYSTEM CONFIGURATION.
2.
Enter the desired DVR ID number.
On the Remote Controller
3.
Press and hold the ID button on the remote controller and enter the desired
DVR ID number to operate the corresponding DVR.
Note
The REMOTE ID must be input as two numbers on the remote controller. Therefore you
should input 00 for the REMOTE ID 0 and input 01 for 1.
Technical Support
(877) 855-1349 • www.toshibasecurity.com
Advertisement
