Installing The Gps Receiver - Parrot Asteroid Smart User Manual

Installing the GPS receiver

Stick the GPS receiver in an unobstructed area inside the car.
Athermic windshields and windows with a built-in antenna can interfere with GPS
reception and reduce the reliability of information from navigation applications.
The GPS receiver antenna is located on the side where "Parrot ASTEROID GPS"
is written and where the star-shaped logo is. This logo must always be directed
towards the sky.
If your vehicle has an athermic windshield, stick the GPS receiver on the windshield on
the non athermic area. The side where the star-shaped logo is must be stuck on the
windshield.
Note : The non athermic area of the windshield depends on the model of your vehicle. It is
usually located near the rear view mirror.
If your vehicle does not have an athermic windshield, stick the GPS receiver on the
dashboard. The side where the star-shaped logo is must be visible.
To make sure the adhesive tape adheres well :
use the provided adhesive tape ;
clean the area with an appropriate cleaning product before sticking the support ;
once you have stuck the support on the dashboard, wait for approximately 2 hours
without handling it.
Note: Once the GPS receiver is connected to the Parrot ASTEROID Mini, the GPS receiver
light stays off while searching for a GPS signal. The light blinks in white as soon as a signal
Installation 11