Advertisement
Checking after Installation
1. Install the product according to the Instructions, check whether all the parts
are firmly connected.
2. Twirl the impeller with insulating material, like batten. Check the normal
rotation and isolation between the blades and casing.
3. Before using, check whether the voltage and frequency on the nameplate
match those in use. Then add water into the tank (manual inflowing or
automatic inflowing). Check whether there is any leakage of the water tank.
4. Power on the product to see its operation. Switch on each speed, check
whether it sounds abnormal, vibrates obviously. Press the button "MIST", 10
seconds later, rotate the "Mist regulating Switch" from "Min" to "Max", and
check whether mist is normal. Power off the product immediately once there
are some abnormalities.
@2012.11-V1.0
WT-4C
Page 7 of 13
Advertisement
