Fleetwood Bounder 2011 Owner's Manual page 96

SOUTHWIND INFORMATION
LAMPS AND BULBS
Replace bulbs with the listed bulb or equivalent.
Interior -12-volt
Bedroom/living room
reading lights .............................. .1 I 39IF, 12-volt
Bedroom soffit lights .................. GE 5312, 12-volt
Dinette decor light... ..................... GE 921, 12-volt
Round Halogen lights ........................ IOW, 12-volt
Vanity light .................................... 9019-F, 12-volt
Extelior
Back-up lights ............................. GE 1156, 12-volt
Entry step light ............................. GE 193, 12-volt
Front clearance lights ................. GE 67DP, 12-volt
Front tum signal
lights ................................................ 7440, 12-volt
Headlight, halogen
high beam ........................................ HB3, 12-volt
Headlight, halogen
low beam ......................................... HB4, 12-volt
License plate light ...................... GE 5312, 12-volt
Mirror tum signal lights ............. GE 1895, 12-volt
Porch lights .......................... .Jensen 1003, 12-volt
Rear clearance lights .................... GE 193, 12-volt
Side marker lights ......................... GE 194, 12-volt
Stop/tum/taillights ...................... GE 1157, 12-volt
Driving Light ..................................... HB4. 12-volt
Fog Light ........................................... HB4, 12-volt
'CAUTION
Before relamping, disconnect power source by remov-
ing fuse or placing circuit breaker and control switch in
OFF position.
Halogen bulbs operate at extremely high temperatures
and pressures and will shatter if not handled correctly.
Always use a soft dry cloth or cotton gloves when han-
dling halogen bulbs.
Do not touch glass area with bare hands. If bulb is
touched with bare hands, wipe the bulb clean with rub-
bing alcohol.
Do not use near flammable or combustible materials
andlor objects which may be sensitive to fading or drying.
Use bulbs designed or specific by manufacturer as to
style, wattage and voltage.
.II
NOTE
I
Consult Chassis Operator's/Owner's Guide/Manual
for automotive lamp replacement on chassis cab. This
would include headlamps, turn signals and running
lamps.
MOTOR HOME FUSES AND
CIRCUIT BREAKERS
The 120-volt circuit breakers and 12-volt fuses
are located on three separate panels. The pur-
pose of these three panels is to provide electrical
circuit breakers and fuses to interrupt cun-ent
flow if a circuit is overloaded.
1.
120-volt House Electrical-
This electri-
cal panel is located under the bed. This
panel is velY similar to a residential panel
with resettable breakers.
2. FleetwoodAutolllotive 12-volt System-
This panel is located in a driver's side com-
partment. This electrical center contains
battery disconnect systems, entry step, fog
light, and some other automotive circuitry.
3. 12-volt Chassis Fuses -
This electrical
panel is located under the driver's side
dash area.
WARNING
Do not install 12-volt fuses or 120-volt breakers with
amperage ratings greater than that specified on the
device or label. Doing so constitutes a fire hazard.
04-7