Fleetwood Bounder 2011 Owner's Manual page 21

LAMPS AND BULBS
Interior - 12-volt
Bedroom decor lights ...................... GE 1076, 12-vol!
BedroomlLiving area lights .............. .l139IF, 12-vol!
Ceiling double incandescent .......... .GE 1141, 12-vol!
Ceiling single incandescent ............ GE 1141, 12-volt
Driver/passenger map lights ............ MR 16C, 12-volt
Living area ceiling decor light.. ........ GE 921, 12-volt
Living area decor light... ................... GE 921, 12-volt
Raund Halogen Lights ........................... 1OW, 12-volt
Vanity Lights ......................................... 9019, 12-volt
Wardrobe light .................................. GE 561, 12-volt
Exterior
Back-up lights ................................ .GE 1156, 12-valt
Ently step light... ............................... GE 194, 12-valt
Front clearance lights ........................... 67DP, 12-vol!
Front side markers/turn signallights ... Sylvania 3457,
12-volt
Headlight, halogen high-beam ... HB3 (9005), 12-valt
Headlight, halogen low-beam ..... HB4 (9006) 12-volt
High turn signal lamps ........... Sylvania 3157, 12-volt
License plate light... ............................ GE 53, 12-valt
Parch lights .................................... .GE 1003, 12-volt
Rear clearance lights ......................... GE 194, 12-volt
Rear turn signal lights ...................... GE 1156 12-volt
Roadside Utility Light ................... .GE 1156, 12-volt
Side marker lights ............................ .GE 194, 12-volt
Stap/turn/taillights ........................... GE 1157, 12-vol!
A
CAUTION
Before relamping, disconnect power source by remov-
ing fuse or placing circuit breaker and contral switch in
OFF
position.
Halogen bulbs operate at extremely high temperatures
and pressures and will shaHer if not handled correctly.
Always use a soft dry cloth or coHan gloves when han-
dling halogen bulbs.
Do not touch glass area with bare hands. If bulb is
touched with bare hands, wipe the bulb clean with rub-
bing alcohol.
Do not use near flammable or combustible materials
and/or objects which may be sensitive to fading or drying.
Use bulbs designed or specific by manufacturer as to
style, waHage and voltage.
BOUNDER INFORMATION
/1
NOTE
I
Consult Chassis Operator's/Owner's Guide/Manual
for automotive lamp replacement on chassis cab. This
would include headlamps, turn signals and running
lamps.
MOTOR HOME FUSES AND
CIRCUIT BREAKERS
The 120-volt cil'cuit breakers and 12-volt fuses
are located on three separate panels. The pur-
pose of these three panels is to p1'Ovide electrical
circuit breakers and fuses to interrupt current
flow if a circuit is overloaded.
1.
120-volt House Electrical -
This electri-
cal panel is located in a cabinet at the foot
of the bed. This panel is very similar to a
residential panel with resettable breakers.
2. Fleetwood Automotive 12-volt System -
This panel is located in a side compartment
or engine access compattment. This electri-
cal center contains battery disconnect sys-
terns, entry step, fog light, and some other
automotive circuitry.
3.
12-volt Chassis Fuses -
This electrical
panel is located under the driver's side
dash area.
WARNING
Do not install 12-volt fuses or 120-volt breakers with
amperage ratings greater than that specified on the
device or label. Doing so constitutes a fire hazard.
04-3