Screen Saver Mode - Panasonic KX-TGH220E Operating Instructions Manual

n When the indicator flashes rapidly,
you can:
– Answer the call (outside call, intercom).
(page 17, 19)
– Stop paging.
– Stop the alarm sound. (page 30)
n When the indicator flashes slowly in
standby mode, you can:
– Listen to new messages. (page 39)
– View the caller list when there are
missed calls. (page 36)
To activate these features, their Smart
Function Key must be "On". (page 15)
Using the Smart Function Key (
key)
When the indicator flashes rapidly/slowly,
press M N.
R The above features can be activated
depending the situation.
R If you answer a call using the Smart
Function Key, the speakerphone is
activated.
R Even if the handset is placed on the base
unit or charger, the feature can be
activated. You can talk or listen to new
messages without lifting up the handset. If
you want to perform further operations, lift
up the handset.
R When the unit has new messages and
missed calls, the unit can be operated to
play the new messages first and then show
the missed calls.
Note:
R While key lock is on (page 19), incoming
calls can be answered, but the following
features are disabled even when the
indicator flashes slowly.
– Listen to new messages. (page 39)
– View the caller list when there are
missed calls. (page 36)
Setting the Smart Function Key
The Smart Function Key for the following
features must be "On".
– "New Message" (Default: On)
– "Missed Call" (Default: Off)
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
TGH22xE(en)_1211_ver031.pdf
The settings can be set for each handset.
1
2
3
Note:
R If the

Screen saver mode

The backlight goes dark when on a call or
turns off completely after 1 minute of
inactivity if the handset is not on the base unit
or charger.
Activate the handset display again by:
– pressing M
– pressing M
Eco mode setting
You can select the desired eco mode setting
by pressing MR/ECON.
The following settings are available for eco
mode.
– "Eco": Reduces the base unit transmission
– "Eco Plus": Reduces the base unit
– "Eco Off" (default setting): Turns off eco
15
Getting Started
MMENUN (right soft key) #278
MbN: Select the desired setting and press
MSELECTN.
R " " is displayed next to the selected
features.
R To cancel a selected feature, press
MSELECTN again. " " disappears.
MOKN a M N
indicator flashes when the
handset is not placed on the base unit or
charger, battery consumption is faster than
usual.
N when on a call.
N at all other times.
power by up to 90 % in standby mode.
When this setting is selected,
displayed on the handset display instead of
.
transmission power completely in standby
mode.
When this setting is selected,
displayed on the handset display instead of
.
mode.
When this setting is selected,
are not displayed in the handset display.
2013/12/11 17:47:41
is
is
/
15