Advertisement
ENGLISH
ELECTRICAL CONNECTIONS
To prevent short circuits, we recommend that you disconnect the battery's negative terminal and
make all electrical connections before installing the unit.
• Be sure to ground this unit to the car's chassis again after installation.
Notes:
• Replace the fuse with one of the specified rating. If the fuse blows frequently, consult your JVC
IN-CAR ENTERTAINMENT dealer.
• It is recommended to connect to the speakers with maximum power of more than 50 W (both at
the rear and at the front, with an impedance of 4 Ω to 8 Ω). If the maximum power is less than
50 W, change "AMP GAIN" setting to prevent the speakers from being damaged (see page 17 of
the INSTRUCTIONS).
• To prevent short-circuit, cover the terminals of the UNUSED leads with insulating tape.
• The heat sink becomes very hot after use. Be careful not to touch it when removing this unit.
Heat sink
A
Typical Connections /
Before connecting: Check the wiring in the vehicle carefully. Incorrect connection may cause
serious damage to this unit.
The leads of the power cord and those of the connector from the car body may be different in
color.
1
Connect the colored leads of the power cord in the order specified in the illustration below.
2
Connect the aerial cord.
3
Finally connect the wiring harness to the unit.
Note: If your vehicle does not have any accessory terminal, move the fuse from the fuse position 1
(initial position) to fuse position 2, and connect the red lead (A7) to the positive (+) battery
terminal.
• The yellow lead (A4) is not used in this case.
Rear ground terminal
Aerial terminal
2
Line out (see diagram
*
2
Before checking the operation of this unit prior to
installation, this lead must be connected, otherwise
power cannot be turned on.
2
*
B6
B5
White with black stripe
White
Left speaker (front)
B1 B3
B5
B7
B2 B4
B6
B8
A5
A7
A2 A4
A8
Black
3
Yellow*
2
)
Red
Blue with white stripe
Brown
6
B4
B3
Gray with black stripe
Gray
Right speaker (front)
•
•
•
•
•
1
2
3
•
B1 B3
B5
B7
B2 B4
B6
B8
A5
A7
A2 A4
A8
15 A fuse
1
A8
To metallic body or chassis of the car
1
To a live terminal in the fuse block connecting to the car battery
A4
2
(bypassing the ignition switch) (constant 12 V)
A7
To an accessory terminal in the fuse block
3
A5
4
To the remote lead of other equipment or automatic antenna if any (200 mA max.)
A2
To cellular phone system
5
B8
B7
Green with black stripe
Green
Left speaker (rear)
3
Fuse position 2 /
Fuse position 1 /
*
1
Not included with this unit
1
*
*
1
*
1
Fuse block
B2
B1
Purple with black stripe
Ω
Ω
Ignition switch
Purple
Right speaker (rear)
Advertisement
