Panasonic KX-TDA0141 Quick Installation Manual page 57

PROBLEM
•
Noise is frequent while
using the PS.
•
Conversations disconnect
while using the PS.
•
"NO SERVICE" is displayed
on the PS's screen.
•
The CS is not busy (i.e., the
status of the LED is not
Moderate Green Flashing),
but calls cannot be made or
received.
•
There is noise during a
phone call.
•
PS stays out of service
when the CS status is
changed from Out of
Service to In Service.
PROBABLE CAUSE
•
Call handover is not
working.
•
PS is out of CS coverage
area.
•
CSs are located too close
together in the same area.
•
It may take about 20 s for
the CS to start up after the
status has been changed
to In Service.
SOLUTION
•
Locate the CS properly (refer to "5 Site
Survey Using the KX-TCA175/
KX-TCA255/KX-TCA256/KX-TCA275/
KX-TCA355/KX-TD7590").
•
Reduce the number of CSs in the area,
or increase the distance between CSs
(refer to "5 Site Survey Using the
KX-TCA175/KX-TCA255/KX-TCA256/
KX-TCA275/KX-TCA355/
KX-TD7590").
•
Wait until the CS starts up.
Quick Installation Guide
9 Troubleshooting
57