Table of Contents
Advertisement
Troubleshooting----------------------------------------------------------------------------------------43
Specifications------------------------------------------------------------------------------------------45
Declaration---------------------------------------------------------------------------------45
Standard Configuration Accessories
Handheld microphone
Holder for handheld microphone
DC power line
Installation support
Screw set
Fuse
Operation Instructions
Installation of Walkie Talkie
Select a safe and convenient site in your vehicle so as to reduce possible damage to your
passenger or yourself during vehicle movement. You may install the walkie talkie blow the
instrument panel in front of the front passenger seats so that your knee and legs will not collide the
walkie talkie. It's best to select a well ventilated site where direct exposure to sun can be avoided.
1. Use the attached self-tapping screws (4) and flat washers (4) to install the installation support in
the vehicle as shown in Fig. 1 and Fig. 2.
Vehicle body
Cone screw
Installation support
Fig. 1
Fig.2
2. Fix the walkie talkie, and then insert and tighten the attached the (4) hexagonal screws as shown
in Fig. 3.
Make sure all screws are tightened to avoid loosening of the support or the walkie talkie in
vibration of vehicle.
Utilize the 3 screw grooves at the side rear side of each support to install the main body at a
proper inclined angle as shown in Fig., 4, 5 and 6.
Fig. 4
Power Line Connection
Operation of talkie walkie
Be sure to use 12V vehicle batteries with sufficient electricity. If the electricity is insufficient,
the display screen will turn dark or the transmission output power may greatly decrease during the
transmission. Never connect the talkie walkie to 24V batteries.
Note: If you use the talkie walkie when the vehicle-use batteries are not sufficiently
charged or the generator is off, battery discharge may lead to insufficient electricity quantity,
making it difficult to start the vehicle. Therefore, try to avoid use the talkie walkie in such
situation.
1. Use the DC power line attached with the talkie walkie to connect the talkie walkie with the
(CTCSS)----------------------------------44
(DCS)-----------------------------------------------------------44
Washer M5
Fig. 3
Fig. 5
Fig. 6
6
Advertisement
Table of Contents
