Table of Contents
Advertisement
adjust the cutting height of the deck to a suitable setting. It may
be necessary to make more than one pass to properly cut a lawn.
1. Turn the mower off and shutoff the fuel cock. Discon-
nect the spark plug wire. Turn the mower on its side.
Fuel tank side must be facing up.
2. Remove the normal cutting blade and replace with
mulching blades
mulching blades. The regular bolts will be too short.
Torque blades to 26 - 33 ft.-lb. (35-45 Nm). Fig. 4-13
3
8
2
1
Fig. 4-13
3. Lift guard and place the spacer
chute. Install and bolt
together as shown. Fig. 4-14
7
4
5
Fig. 4-14
. Use the bolts
supplied with the
Torque blade bolt to
26 - 33 ft.-lbs.
(35 - 45 Nm)
in the discharge
the two clips
7
9
4. Insert the plug
normal operating position. Fig. 4-15 and Fig. 4-16
and
Guard
4-6
and allow the guard to return to the
6
Fig. 4-15
Fig. 4-16
108548_0609
6
Advertisement
Table of Contents
