Table of Contents
Advertisement
Foretravel Owners Manual
Section 4 - Familiarization of Your New Motorhome
Headlights
Press right side of headlight switch on the dash to first stop (center posi-
tion) for parking lights and to second stop (top position) for headlights. Rota-
tion of dimmer controls regulate brightness of the instrument or accessory
panel lighting.
The headlight dimmer switch is on the turn signal lever, and is operated by
pulling the lever up.
S
W
C
MART
HEEL
ONTROLS
Flash (ICC Courtesy)
When headlights are on and switch on the left is depressed, headlights will
go off until switch is released. When headlights are on and switch on the right
is depressed, clearance lights will go off until switch is released.
When headlights are off and switch on the left is depressed, headlights will
go on until switch is released. When headlights are off and switch on the right
is depressed, clearance lights will go on until switch is released.
Windshield Wiper and Washer System
The windshield wiper/washer system is controlled by the Smart Wheel.
Press the HI/LO switch to toggle between high and low speed. Press the DE-
LAY switch to activate the wiper delay system. The washer is activated by
pressing the wash switch. The OFF switch turns the system off.
Operation of the Wiper Variable switch initially causes the Low Speed
Wiper function to activate for one wipe. If the switch is pressed again within
approximately 30 seconds, the Low Speed Wiper function will be activated
again and will repeat at an interval determined by the time between the last two
operations of the switch. Additional switch operations will shorten the cycle.
Activation of any other wiper mode cancels the variable mode. The effect for
the driver is thus: In light rain or mist conditions the driver presses the switch
once when the windshield first needs clearing. When the windshield again re-
quires clearing the driver presses the button again - setting the time period be-
tween subsequent wipes to that required by current conditions.
Activation of any wiper function generates a "Headlamp On" signal from
the Master which will only be reset by turning off the ignition.
Cruise Control
Controls for the cruise control are located on the steering wheel. You must
press the "ON" button before the cruise control will operate. With the cruise
control turned on, bring your speed up to the point you wish to maintain and
then use the "SET" button . Now your cruise control will maintain this speed
Rev. 06-02
Page 4-3
Advertisement
Table of Contents
