Table of Contents
Advertisement
Please familiarize yourself with the following information to prevent
damage to your compressor unit and injury to the operator.
CAUTION
The compressor operates automatically while the power is connected and
turned on, or the engine is running .
WARNING
spraying paint or chemicals, or when sandblasting . Always wear safety glasses
or goggles when using compressed air .
It is not practical or possible to warn you about all the hazards associated
with operating or maintaining this equipment . You must use your own good
judgment .
ExTENSION CORdS
The use of extensions cords is not recommended . Plug directly into a
dedicated circuit . If the use of an extension cord is unavoidable then make
sure your extension cord is in good condition . When using an extension
cord, be sure to use one heavy enough to carry the current your product will
draw . An undersized cord will cause a drop in line voltage resulting in loss of
power and overheating . Table 1 shows the correct size to use depending on
cord length and nameplate amperage rating . If in doubt, use the next heavier
gauge . The smaller the gauge number, the heavier the cord .
More Than
0
6
10
12
AIR RECEIVER
Over pressurizing the air receiver could cause personal injury or material
damage . To protect from over pressurizing, a factory pre-set safety valve is
4
SAFETY PRECAUTIONS
The air compressor motor and/or engine will get hot
while in operation . Never touch the discharge tubing,
engine, motor or compressor pump while in operation .
Compressed air from the unit may contain hazardous
fumes . Air produced by this compressor is not suitable
for breathing purposes . Always use a respirator when
Table 1 — Minimum Gauge for Cord
Ampere Rating
Not More Than
6
10
12
16
Volts
Total length of cord in feet
120 V
25 ft .
50 ft .
AWG
18
16
18
16
16
16
14
14
100 ft . 150 ft .
16
14
14
12
14
12
Not Recommended
Hide quick links:
Advertisement
Table of Contents
