Table of Contents
Advertisement
Recommended minimum WiRe
gauge FoR eXtenSion coRdS
(120 Volt)
nameplate
ampeReS
(at full load)
0 – 6
6.1 – 10
10.1 – 12
12.1 – 16
table a
7.
USE PROPER EXTENSION CORD.
Make sure your extension cord is in good
condition. When using an extension
cord, be sure to use one heavy enough
to carry the current your product will
draw. An undersized cord will cause a
drop in line voltage resulting in loss of
power and overheating. Table A shows
the correct size to use depending on
cord length and nameplate ampere
rating. If in doubt, use the next heavier
gauge. The smaller the gauge number,
the heavier the cord.
8.
WEAR PROPER APPAREL. Do not wear
loose clothing, gloves, neckties, rings,
bracelets, or other jewelry which may get
caught in moving parts. Nonslip footwear
is recommended. Wear protective hair
covering to contain long hair.
9.
ALWAYS USE SAFETY GLASSES. Also
use face or dust mask if cutting operation
is dusty. Everyday eyeglasses only have
impact resistant lenses, they are NOT
safety glasses.
10.
MAINTAIN TOOLS WITH CARE. Keep
tools sharp and clean for best and safest
performance. Follow instructions for
lubricating and changing accessories.
11.
DISCONNECT TOOLS before servicing;
when changing accessories, such as
blades, bits, cutters, and the like.
SKU 67631
eXtenSion coRd
length
25'
50'
100'
18
16
16
18
16
14
16
16
14
14
12
do not use.
For technical questions, please call 1-800-444-3353.
12.
REDUCE THE RISK OF
UNINTENTIONAL STARTING. Make
sure switch is in off position before
plugging in.
13.
USE RECOMMENDED ACCESSORIES.
150'
Consult the owner's manual for
recommended accessories. The use of
14
improper accessories may cause risk of
12
injury to persons.
12
14.
CHECK DAMAGED PARTS. Before
further use of the tool, a guard or other
part that is damaged should be carefully
checked to determine that it will operate
properly and perform its intended
function – check for alignment of moving
parts, binding of moving parts, breakage
of parts, mounting, and any other
conditions that may affect its operation.
A guard or other part that is damaged
should be properly repaired or replaced.
gRounding inStRuctionS
110-120 V~ grounded tools: tools
with three prong plugs
1.
In the event of a malfunction or
breakdown, grounding provides a path
of least resistance for electric current
to reduce the risk of electric shock.
This tool is equipped with an electric
cord having an equipment-grounding
conductor and a grounding plug. The
plug must be plugged into a matching
outlet that is properly installed and
grounded in accordance with all local
codes and ordinances.
to pReVent
electRic Shock
and death FRom incoRRect
gRounding WiRe
connection
Read and FolloW theSe
inStRuctionS:
Page 3
Hide quick links:
Advertisement
Table of Contents
