Parameters; Switching The Remote Control Id - Yamaha RX-497 Owner's Manual

ADVANCED SETUP
3
Press the preset station/channel number
buttons (1 and 2) on the front panel
repeatedly to move through the menu and
select the parameter you want to adjust.
See page 35 for a complete list of available
parameters.
You can select the unit you want to operate with the
remote control by switching the remote control ID.
1
Press and hold CODE SET on the remote
control and then press TUNER on the remote
control.
4
Press AlB/C/D/E on the front panel
repeatedly to toggle between the available
parameters.
AlBICIDIE
5
Press MASTER ON/OFF to release it outward
to the OFF position to confirm your setting.
The settings you made are reflected next time you turn on the
power of this unit.
36
2
While holding down CODE SET on the
remote control, use the numeric buttons on
the remote control to enter the three-digit
code number listed in the table below.
Remote
control 10*
Function Code number
(th is unit's
setting)
To operate this
IDI unit using an
801
alternative code.
ID2
To operate this
(default setting)
unit using the 802
default code.
* When you change the remote control ID, you must switch
the remote control ID of this unit (see page 35).
When using multiple YAMAHA receivers or
amplifiers with the same default code setting, you
may unwantedly operate those components
simultaneously. In this case, set one of the alternative
codes for this unit to operate this unit separately.
Also change the remote control ID of the Zone 2 remote control
(sold separately) (see page 9).
ADVANCED SETUP
3
Press the preset station/channel number
buttons (1 and 2) on the front panel
repeatedly to move through the menu and
select the parameter you want to adjust.
See page 35 for a complete list of available
parameters.
You can select the unit you want to operate with the
remote control by switching the remote control ID.
1
Press and hold CODE SET on the remote
control and then press TUNER on the remote
control.
4
Press AlB/C/D/E on the front panel
repeatedly to toggle between the available
parameters.
AlBICIDIE
5
Press MASTER ON/OFF to release it outward
to the OFF position to confirm your setting.
The settings you made are reflected next time you turn on the
power of this unit.
36
2
While holding down CODE SET on the
remote control, use the numeric buttons on
the remote control to enter the three-digit
code number listed in the table below.
Remote
control 10*
Function Code number
(th is unit's
setting)
To operate this
IDI unit using an
801
alternative code.
ID2
To operate this
(default setting)
unit using the 802
default code.
* When you change the remote control ID, you must switch
the remote control ID of this unit (see page 35).
When using multiple YAMAHA receivers or
amplifiers with the same default code setting, you
may unwantedly operate those components
simultaneously. In this case, set one of the alternative
codes for this unit to operate this unit separately.
Also change the remote control ID of the Zone 2 remote control
(sold separately) (see page 9).