Installer Setup Flowchart; Set Service - Honeywell Y9420H Sundial RF2 Pack 2 Installation Instructions Manual

3.4 Installer Setup Flowchart

3.5 Set Service

Set Service parameters are listed in the table below, along with a description of the options that are possible.
'SET SERVICE'
PARAMETER
Enable or disable service
alarm feature
Number of days till next
Service
Number of days for
advance warning
Action taken at time-out
Number of EXTRA HOUR
button presses allowed in
'Prompt' mode
Enable telephone call
number display
Enter telephone STD code
Enter telephone number
* Reset 'SET SERVICE'
parameters to default values
* This parameter by default has a value of 1, unless any other parameter is adjusted, when it will change to 0. Set it to 1 to reset all parameters
back to defaults
Parameter LoT™ Display
ID Description
AL SERV MODE
d SERV DAYS
Ad DAYS NOTICE
to ACTION TYPE
bP 1HR BOOSTS
tC SHOW
PHONE
St STD CODE
nU NUMBER
rS ALRM RESET
LoT™ Display
Parameter
Number
Default Range of Description [LoT™ Display Description]
Value Values
0 0, 1 0 = disabled
1 = enabled
364 001 to 001....400
400 000 = service is overdue
28 0 to 28 0 ...28
2 0, 1, 2 0 = no action,
1 = switch off,
2 = 'prompt' mode
uL uL, uL = unlimited number,
1 to 99 1...99 = specified number of button
presses, after which unit switches off
0 0, 1 0 = disabled
1 = enabled
------- 1 When a
shows a row of dashes which can be adjusted using
buttons, then verified using the
--------- 1 When a
shows a row of dashes which can be adjusted using
buttons, then verified using the
1 0,1 0 = do not reset
1 = default parameters
10
or
Parameter
Value
[DISABLED]
[ENABLED]
[SET DAY COUNT]
[SET DAYS NOTICE]
[NO ACTION]
[SWITCH OFF]
[PROMPT MODE]
[NUM BOOSTS]
[DISABLED]
[ENABLED]
or button is first pressed the LoT™ Display
button.
or button is first pressed the LoT™ Display
button.
[NO RESET]
[RESET]
or
or