JVC LVT1003-001B Instruction Manual page 33

Connecting the parking brake cord /
When installing the monitor in a location
which can be seen by the driver
!"#$%&'= !"#
Parking brake lever
Connect the light green cord to the parking
brake system.
!"#$%&'()(*+,-
PRECAUTIONS on power supply and
speaker connections:
• DO NOT connect the speaker leads of the power
cord to the car battery; otherwise, the unit will
be seriously damaged.
• Connect the black lead (ground), yellow lead (to car
battery, constant 12 V), and red lead (to an
accessory terminal) correctly.
• BEFORE connecting the speaker leads of the power
cord to the speakers, check the speaker wiring in
your car.
– If the speaker wiring in your car is as
illustrated in Fig. 1 and Fig. 2 below, DO NOT
connect the unit using that original speaker
wiring. If you do, the unit will be seriously
damaged.
Redo the speaker wiring so that you can connect
the unit to the speakers as illustrated in Fig. 3.
– If the speaker wiring in your car is as
illustrated in Fig. 3, you can connect the unit
using the original speaker wiring in your car.
– If you are not sure of the speaker wiring of your
car, consult your car dealer.
!"#
Connecting the leads /
Twist the core wires when connecting.
!"#$%
B Connections Adding Other Equipment /
You can connect an monitor and other equipment to
upgrade your car stereo system.
• Connect the remote lead (blue with white stripe) to
the remote lead of the other equipment so that it
can be controlled through this unit.
• For amplifier only:
– Connect this unit's line-out terminals to the
amplifier's line-in terminals.
– Disconnect the speakers from this unit,
connect them to the amplifier. Leave the
speaker leads of this unit unused. (Cover the
terminals of these unused leads with
insulating tape, as illustrated above.)
Monitor / / /
• Before connecting the monitor, make
sure that the unit is turned off.
!"#$%&'()*+,
•
•
•
!" /
Amplifier /
Rear speakers
!
INPUT
L L
R R
JVC
Signal cord (not supplied with this unit)
!"#$%&'()
LINE OUT
L
L L
REAR
R
R R
Front speakers
!"
!"!#$% /
Foot brake
!"
Crimp connector
!"
Parking brake switch
!"#
!"#$%&'()*
!"#$%&'&()*+,-./0123
•
!"#$%&"'(" )*+$%&"'
•
!"#$%& 12V
!"#$%&'()
!"#$%&%' !"()*+,-./0
•
!"#$
!"#$%&'()* 1
–
!"#$%&'()*+
!"#$%&'()*+ 3
!"#$
!"#$%&'()* 3
–
!"#$%&'()*
!"#$ %&'()*+,-./ 0%
–
!"#$
+ +
+ +
L
-
L -
- -
+
+
+ + R
- -
R
-
-
Fig. 1 Fig. 2
/ /
Solder the core wires to connect them securely.
!"#$%&'()
!"#$%&'( /
!"#$%&'()*+, -./0123
!"#$%&'$()*+,-./01
•
!"#$%&$'()*+,-./
!"#$%
•
!"#$%&'()"*$%+,-./
–
!"#$%&'()*+,!- #$.
–
!"#$%&'()*+,-./01%2
!"#$%&'()*
Video out Signal cord
(not supplied with this unit)
!"#$%&'(
KD-SV3000
/
Remote lead
!"
JVC Amplifier
!"
JVC
Blue with white stripe
!" #$
3
*
L
FRONT
R
KD-SV3000
You can connect another power amplifier for front speakers.
!"#$%&'()*+,-./&0
/
KD-SV3000
!"
To metallic body or chassis of the car
!"# $%&'
•
!"#$%&$'
•
•
2
,-./01
–
!"#$
!"
–
+ +
L –
- -
+ +
R
-
-
Fig. 3
CAUTION /
• To prevent short-circuit, cover the terminals of the UNUSED
leads with insulating tape.
!"#$%&'()*+,-.'!/0123
•
•
•
•
–
–
Monitor connection unit
(supplied with KV-MR9000)
=KV-MR9000
KV-MR9000
Y-connector (not supplied with this unit)
!"#$%&'()*
Y
Y
INPUT
JVC Amplifier Front speakers
L
!"
JVC
R
JVC
4
When installing the monitor in a location
which cannot be seen by the driver
!"#$%&'()*+,-
Connect to metallic body or chassis
of the car with the ground lead.
!" #$%&'()*%
*
*
*
/ /
•
/
!"
KV-MR9000 Wide color monitor
!"#
KV-MR9000
KV-MR9000
KV-MR9000
KV-MR9000
*3: Firmly attach the ground wire to the metallic
body or to the chassis of the car—to the place
not coated with paint (if coated with paint,
remove the paint before attaching the wire).
Failure to do so may cause damage to this unit.
*3:
To other equipment
!"#$%
*3:
!"
* 3
KD-SV3000
*
2
Parking brake connection
* wire (light green)
2
!"#$%
!"
2 Not included with this unit.
!"#$
==
2
2
*
•
•
•
–
–
–
•
•
–
–
• You can use either INPUT 1 or 2 when
connecting this unit to KV-MR9000.
!"#=KV-MR9000 !
•
INPUT 1 =2
•
KV-MR9000
2 •
INPUT 1
KV-MR9000
!"#$%&'($)*+,-./-.0
!"#$%&'()*+,#$-./01
!"#$%&'()*+,- ./012
*