Receiver Back End; Vhf Transmitter Power Amplifier (136-162 Mhz); First Power Controller Stage - Motorola Radius CM200 Service Manual

2-2
2.2

Receiver Back End

The IF signal from the crystal filter enters the IF amplifier which provides 20 dB of gain and feeds
the IF IC at pin 1. The first IF signal at 44.85 MHz mixes with the second local oscillator (LO) at
44.395 MHz to produce the second IF at 455 kHz. The second LO uses the external crystal Y301.
The second IF signal is amplified and filtered by two external ceramic filters (FL303/FL302 for
12.5 kHz channel spacing and FL304/FL301 for 25 kHz channel spacing). The IF IC demodulates
the signal by means of a quadrature detector and feeds the detected audio (via pin 7) to the audio
processing circuits. At IF IC pin 5, an RSSI signal is available with a dynamic range of 70 dB.
3.0 VHF Transmitter Power Amplifier (136–162 MHz)
The radio's 45 W PA is a three-stage amplifier used to amplify the output from the TX_INJ to the
antenna port. All three stages utilize LDMOS technology. The gain of the first stage (U101) is
adjustable and is controlled by pin 7 of U103-2 via U103-3 and U102-1. It is followed by an LDMOS
driver Q105 and final stage Q100.
From VCO (TX_INJ)
Controlled
Stage
Devices U101, Q105 and Q100 are surface mounted. Two screws with Belleville washers provide
direct pressure ensuring good thermal contact between both the driver and final stage, and the
chassis.
3.1

First Power Controller Stage

The first stage (U101) is a 20dB gain integrated circuit containing two LDMOS FET amplifier stages.
It amplifies the RF signal from the VCO (TX_INJ). The output power of stage U101 is controlled by a
DC voltage applied to pin 1 from the op-amp U103-3, pin 8. The control voltage simultaneously
varies the bias of two FET stages within U101. This biasing point determines the overall gain of
U101 and therefore its output drive level to Q105, which in turn controls the output power of the PA.
PA
PA-Final
Driver
Stage
Bias
Bias
A SF I C_ C MP
SPI BUS
Co n t r o l le r
U1 0 3 - 2
Figure 2-2 VHF Transmitter Block Diagram
Pin Diode
Antenna
Switch
Coupler
Forward
PA
PWR
SET
L oo p
THEORY OF OPERATION
Antenna
Harmonic
Filter
RF Jack
Temperature
Sense