Advertisement
1.
Remove Fuelpak clear case cover by removing all four screws, save hardware.
2.
Refer to Fuelpak Setting Reference to locate the Setting Values specific to your configuration. If you do not
find your setting, visit fuelpakfi.com or call tech support at (562) 921-0071.
3.
With run/kill switch in "run" position, turn on main power with key, but do not start engine. Fuelpak display
should light up, if not, turn power off and verify the connectors are fully seated.
4.
Press thumb throttle to the full throttle position and release before Fuelpak turns off.
5.
Start engine. By pressing the mode select button twice, move to mode 21 and verify that it reads between
"0" and "10" with the throttle closed and increases gradually as you press on the throttle. If not, turn off
engine and go back to step 2. Do not proceed to step 6 until mode 21 is verified.
6.
Press mode select button to get to mode 1. Starting with mode 1 selected, press the value (+) or the value (-)
buttons to input the correct value as indicated in your Setting Value. After entering your first value, press the
mode select button to move to mode 2 and enter the value. Continue until you have entered the value for
each of the first 18 mode positions. Each time the value (+) is pressed, the value increases by one number.
Each time the value (-) is pressed, the value decreases by one number. (Please refer to the "How It Works"
section directly above if you have questions about this step.
7.
Press mode button 5-times to move to mode 23. Enter any other mode values as required for your
application.
8.
Turn off power.
9.
Reinstall clear case cover and mount as described.
10.
Reinstall seat.
11.
You are now ready to ride.
1.
Turn off main and handlebar switches then verify all
connectors are fully seated.
2.
Be sure setting values are correct for your application.
3.
Verify throttle calibration, step 5 in Entering Values.
WARRANTY: Your Fuelpak unit is warranted against defects
in materials and workmanship for the period of 90 days from
the original retail purchase. In the event of an alleged defect
in material or workmanship, Fuelpak's responsibility is strictly
limited to repair or replace the defective product. Fuelpak
shall not be responsible for (a) labor, transportation, or other
incidental charges; (b) consequential or other damages
incurred by use of any product. Fuelpak offers no other
warranty beyond this limited warranty. This limited warranty
does not apply to products which have been (a) modified
or altered in any way; (b) subjected to adverse conditions,
such as misuse, neglect, accident, improper installation
IN THE EVENT OF A MALFUNCTION, PLEASE CHECK THE FOLLOWING
WARRANTY INFORMATION
4.
Check harness for cuts, scrapes or abrasions.
5.
Make sure the battery is fully charged and the
charging system is operating correctly.
6.
Call technical support at (562) 921-0071
or adjustment, contaminants, corrosion, or faulty repair;
or (c) used in applications other than those recommended by
Fuelpak. To initiate a warranty process, the consumer must first
call technical support to receive a return authorization number.
The product must be returned to Fuelpak complete with a dated
receipt and a return authorization number.
Fuelpak
Attn: Warranty Claims
13861 Rosecrans Avenue
Santa Fe Springs, CA 90670
(562) 921-0071
P/N 51754 092007
Advertisement
