℃ (e.g. in automobile). Otherwise the electronic parts may be damaged. Be cautious when using the CL-360 on your camera. CL-360 is heavier than a typical shoe mount flash so a CL-360 on your camera may damage the camera hotshoe.
19. SET Button 20. ON/OFF Power Switch 21. Test Button/ Flash Ready Indicator 22. Select Dial The flash unit is not powered by itself, but draws power from Cheetah Lithium Battery Pack L4500 (sold separately). - 03 - - 04 -...
3. Turn on the power pack. Normally the flash unit will be fully charged and ready to work. The flash unit is not powered by itself, but draws power from Cheetah Lithium Battery Pack L4500 (sold separately). For the instructions of the power pack, see the related user manual.
1/4+0.7 1/4+0.3 There is a 1/4″ mounting hole at the bottom of the off-camera adapter. After replacing the adapter, the flash can be used mounting on CL-360 portable light boom, and ←Figures displayed when increasing flash output level almost any other light stand. To install the off-camera adapter.
1/128 To control the flash wirelessly, you need a Cheetah CL series remote control set (CL-Tx and CL-Rx). Insert CL-Rx receiver into the Wireless Control Port (7) on the flash and put CL-Tx transmitter on top of the camera hot shoe. Settings made on...
Horizontal Rotation Angle 0 to 270° Power Supply Cheetah Lithium power pack L4500 Protection Function Full Power Flashes 450 (with Cheetah Lithium power pack L4500) Approx. 0.05-4.5s (with Cheetah Lithium power pack) Recycle Time Over-Temperature Protection 5600±200K Color Temperature To avoid overheating and deteriorating the flash head, do not fire more than 75 continuous flashes in fast succession at 1/1 full power.
Need help?
Do you have a question about the CL-360 and is the answer not in the manual?
Questions and answers