Cleaning The Appliance - Venini VEF91EG Installation, Maintenance And Use Instructions

Setting error identification
The setting is correct if the time of day is in between the calculated cooking start and end times. If an error has been
made, this will be indicated by the audible signal and by the symbol "A" flashing. The faulty setting can be corrected by
changing one or both functions.
Cancelling programme
A programme can be cancelled by selecting the manual function. After a programme which has been set comes to an
end, it is automatically cancelled.
Fig. 39

CLEANING THE APPLIANCE

Before cleaning the appliance, it should be disconnected from the power supply and turn off the main gas
feeder valve.
Cleaning the work surface
Periodically clean the burner heads, the enamelled steel grids, the enamelled covers and the flame caps using warm
soapy water. Then those parts should be rinsed and thoroughly dried.
Any liquid that overflows from pots must always be removed using a rag.
If it becomes difficult to open or close a valve, do not force it, but immediately request the assistance of the
technical service personnel.
Cleaning the enamelled parts
To maintain the original features of the enamelled parts they should be cleaned frequently with soapy water. Never use
abrasive powders. Do not leave acidic or alkaline substances on the enamelled parts (vinegar, lemon juice, salt, tomato
sauce, etc.) and do not wash the enamelled parts while they are still hot.
Cleaning the STAINLESS steel parts
Clean the parts with soapy water and then dry them with a soft cloth. The shine is maintained by periodically using
special products that generally are found in the market. Never use abrasive powders.
Cleaning the burner flame caps
Since the flame caps are resting on the burner, to clean them just remove them from their seat and wash them with
soapy water. After they have been thoroughly dried and having checked that the holes are not clogged, they can be
replaced in their proper position.
Cleaning the inside of the oven glass
One of the features of the oven is the possibility of removing the interior glass simply by loosening the 2 screws B (Fig.
41), to clean the inside surface of the glass (Fig. 40). This operation should be carried out while the oven is cold and with
a damp cloth. Do not use abrasives.
Cleaning the inside of the oven
To thoroughly clean the inside of the oven, it is recommended to disassemble the door by carefully following the
instructions described below. Insert the hook C into the hinged sector D. Put the door in a semi-open position and using
both hands pull it towards you until it is released from the attachment. To replace the door, do the opposite making sure
to insert the two sectors F correctly. In addition, the side shelves can be removed very easily, by loosening the lock rings
that attach them to the oven.
30