ViaSat SurfBeam Installation And Configuration Manual page 15

Note Instead of typing the
entire command, you may
type the first few characters
of the command and press
Enter. (e.g., type "dow"
instead of "downstream-
frequency", or "ups" instead
of "upstream -search").
Note The downstream
frequency is the SM receive
frequency, and the upstream
frequency is the SM transmit
frequency.
Note If an out-of -range
value is entered, the
program will display the
correct range.
Rev. B
SurfBeam Satellite Modem Installation and Configuration Guide
10. After the login is successful, you will see the Available commands
screen as shown in the example below.
11. At the SM> prompt , enter downstream- frequency. The existing
downstream frequency will be displayed. You may either accept the
current frequency, or enter a new frequency and press the Enter
key. If you do not want to change the existing frequency, just press
Enter. An example is shown below.
12. At the SM> prompt , enter upstream-search. Each of the upstream
parameters and the current value will appear each time the Enter
key is pressed. Either accept the current value, or enter a new
value and press Enter. If you do not want to change the existing
value, just press Enter. Refer to Table 2-1 for command parameter
details. An example is shown below.
VSD-200292-02-085
2-3