Hardware Setup; Getting Started - Contec SVR-MMF(FIT) User Manual

4. Hardware Setup

Getting Started

Follow the following procedures to set up the SVR-MMF(FIT):
STEP1
STEP2
STEP3
Connecting the F&eIT series module
By referring to this chapter connects the F&eIT series
module to the SVR-MMF(FIT). When using the
SVR-MMF(FIT) on a standalone basis, go to STEP2.
Connecting the cables
Connect the LAN cable and any modem or other external
device cables to the SVR-MMF(FIT).
Turning on the power
After re-checking that STEPS 1 to 2 have been correctly
performed, turn on the power. If something goes wrong
after the power is turned on, immediately turn off the
power and make sure that the system is correctly set up.
SVR-MMF(FIT)
Hardware Setup
19