Table of Contents
Advertisement
english
General information
Parameter change
In order to modify the display and seconds freezing parameters for the
automatic activation of the seconds timer, press the
button as they
are being displayed for 2 seconds.
The instrument enters "programming parameters" and lights up the sign
SET.
The value of freezing seconds flashes on the screen and after the SPLIT
In order to switch to the programming of the automatic activation of the
seconds timer, it is necessary to operate the R or L key.
If you press one of these keys again, the instrument will go back to the
programming of theSPLIT time
Use
and
to change the value of the selection.
The freezing time varies from a minimum of 1to a maximum of 15 seconds
or it can be disabled by selecting "no".
The value of the seconds required to activate the automatic seconds timer
goes from a minimum of 1 to a maximum of 30 seconds
Exit with/without saving
In order to exit and to permanently save the modified parameters, press the
key.
In order to exit, without applying any change and therefore leaving the
previous values unchanged, press the
key.
In both cases, the instrument switches to "Main clock".
Turning off the instrument
Anytime, in order to turn off the instrument, just hold the O key pressed until
the caption "OFF" is displayed.
When you release the key, the [ turns off.
3
Advertisement
Table of Contents
