Table of Contents
Advertisement
Installation of this product is restricted to indoor locations by licensed plumbing or electrical
contractors only. By installing this product you acknowledge the terms of manufacturer's warranty and
your authorized dealers return policy. Water heaters that have been installed cannot be returned.
If you plan to install your water heater on a second floor/above ground or in a heated attic space you must
follow all code requirements for installation in your area. It is highly recommended to install a drip pan
connected to a safe drain as per code requirements, below the water heater to avoid property damage in
case of eventual leaks, and / or install an active water leak detector and shut off valve to turn off your
water supply in the event that a leak is ever detected.
■ Important Safety Instructions
1. The installation must be in compliance with
plumbing codes.
2. This appliance must be GROUNDED.
3. All wiring and installation jobs must be supervised by a qualified electrician.
4. CAUTION: This product has more than one power-supply connection point. Disconnect all power supplies
before
servicing.
5. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do
not play with the appliance.
6. This appliance MUST be permanently connected to a fixed circuit breaker and it must be installed vertically. DO
NOT install this appliance near flammable substances or near a strong magnetic field place.
7. It is forbidden to switch on this appliance if you think it may be frozen, as this could result in serious damage to
the unit. Wait until you are sure that it has completely thawed out before switching it on.
8. Please check the hot water temperature with your hand to make sure it is at a comfortable temperature before
taking a shower to avoid getting scalded.
9. Before connecting pipes to the water heater hoses, it is extremely important to FLUSH the pipes to wash away all
plumbing paste or residue in the pipes.
10. The heating chamber is treated with composite nano-insulation material; it is natural there might be a bit of smell
or green blue smoke when the unit is used for the first time.
11. If there is damage to the wire, you must contact a qua lified electrician to replace it with an approved wire.
12. CAUTION: FOR HOUSEHOLD AND INDOOR USE ONLY
13. Combustible materials should be kept at least 2 ft away from your water heater and output water pipe.
14. AFTER TIGHTENING BOTH FITTINGS AT THE WATER HEATER OPEN SEVERAL HOT WATER FAUCETS
AND ALLOW WATER TO RUN THROUGH THE WATER HEATER FOR AT LEAST 3 MINUTES. THIS
PROCESS PURGES ALL AIR FROM THE WATER LINES AND HEATER.
HIS PROCESS MUST BE PERFORMED PRIOR TO TURNING ON THE POWER OF THE WATER HEATER.
FAILURE TO FOLLOW THIS STEP CAN CAUSE PERMANENT DAMAGE TO THE HEATING ELEMENT.
the National Electrical Code,
2
your local electrical and
Advertisement
Table of Contents
