Table of Contents
Advertisement
Perform reassembly by reversing the order of the disassembly procedure. However, note the following
precautions:
1. Making Power Supply Section Wiring Connections
(1) Be sure to make wiring connections according to the wiring diagram. Pay attention to the colors of
Internal Wires (14)[14] and the terminals to be soldered.
• Wiring diagram
Solder
Internal Wire (red)
Internal Wire (white)
Internal Wire (black)
Controller (C) (16)[16]
(2) When soldering the white and red internal wires to the Motor DC 10.8 V (17)[17], pay attention to the
polarities of the Motor DC 10.8 V (17)[17]. The area around the plus (+) terminal of the Motor DC 10.8
V (17)[17] is marked red.
(3) When soldering the white, red and black internal wires to the terminals of the Switch (13)[13], pay
attention to the mounting direction.
(4) When connecting the Controller (C) (16)[16] to the Switch (13)[13], pay attention to the colors of
Internal Wires (14)[14] and the direction of soldering.
(5) Next, have on hand the assembly consisting of the Motor DC 10.8 V (17)[17], Controller (C) (16)[16]
and Switch (13)[13], and place this assembly within housing (A), which is a part of the Housing (1)[1].
In this case, align the concave part of the Motor DC 10.8 V (17)[17] with the convex part of housing (A).
Also make sure that the concave part of the Controller (C) (16)[16] is aligned with the convex part of the
Housing (1)[1].
• Motor polarities
Plus (+) terminal
Concave
Minus (-) terminal
Reassembly Procedure
Internal Wire (white)
Solder
Switch (13)[13]
• Incorporating the controller (C)
Red mark
Solder
Motor
DC 10.8 V
(black)
(17)[17]
Controller (C) (16)[16]
Concave
Convex
Concave
Convex
-11-
(Red)
(white)
(white) -
Advertisement
Table of Contents
