Table of Contents
Advertisement
E1 - top
E2 - fabric bac
E3 - 'U' frame
1.
Insert 'U' frame through side sleeves of fabric
bag and then into the hard top, ensuring the
small metal pip (F1-A) is securely located (F2-A).
2.
Attach lower sleeve of fabric bag to 'U' frame
(F2-B).
3.
Starting at front end of the top (F3), insert the
Please Note: Ensure no gap remains between the safety flap and the grassbox/bag.
Where grass collection is not required you can use the lawnmower without the grassbox/bag.
Ensure the safety flap is fully closed.
J1 - Indicator lamp
CHARGE THE BATTERY
•
Before using for the first time
•
If your lawnmower is not used for more than
one month.
•
ALWAYS charge the battery immediately
after use!
•
The battery should be charged for 18 hours
before use.
•
Re-charge your battery immediately after
use for the full 18 hour charging period.
•
It is recommended that the battery is left on
charge permanently, whilst not in use. There
is no risk of overcharging.
•
Use the charger indoors only.
•
Ensure the charger is not exposed to
moisture. Keep the charger and the battery
dry at all times. Keep the charger well
ventilated during charging.
1.
Remove the safety key (G).
2.
Connect the charger to the lawnmower (H).
3.
Plug the charger into a suitable household
electrical wall socket and switch on.
4.
The red indicator lamp glows continuously
1.
Adjust to the desired cutting height by means of the lever on the left side of the mower (M).
To Start your Lawnmower
1.
Make sure the safety key is in place before
starting.
2.
Tilt the handle downwards to slightly raise the
front of the lawnmower and to reduce the risk of
lawn damage whilst starting.
The switchbox is provided with a lock-off button
(N1) to prevent accidental starting.
3.
Press and hold the lock-off button (N) on the
switchbox, then squeeze one of the Start/
Stop levers towards the upper handle (P).
This lawnmower is fitted with an overload cutout switch (R). If the motor stops: release the start/stop lever,
wait 20 seconds then press the cutout reset button. If your lawnmower persistently cuts out, without being
unduly loaded consult your nearest Service Centre.
NOTE: Increasing the height of cut will help prevent motor overload.
ENGLISH - 3
Grassbox Assembly - Fabric Bag
Battery Charging
Cutting Height Adjustment
Starting and Stopping
Automatic Overload Cutout
fabric bag rim into the inside edge of the top
until it clicks into each of the location points
(F3-A). Keep inserting the rim around the top
until the fabric bag is secure.
4.
Locate fully assembled grassbox onto 2
location points at the rear of the deck.
5.
Locate safety flap onto the top of the grassbox
(F4). Ensure the grassbox is securely located.
•
Removal is the reverse procedure.
during charging. (J)
5.
Full charge will be achieved in 18 hours. During
charging the charger becomes warm. This is
normal and means the charger is operating
correctly.
•
When the battery is fully charged the red
indicator lamp change to green and flash briefly.
After the brief flashing period the green light
stays on permanently to indicate the battery is
re-charged and is now receiving a trickle
charge.
BEFORE USE
1.
Switch off at the mains and disconnect charger
from lawnmower. (K)
2.
Replace the safety key. (L)
•
Avoid running the lawnmower into "deep"
discharge, i.e. avoid flattening the battery
completely.
•
Charging the battery according to these
instructions should ensure maximum battery
life.
•
Only use the charger supplied with this
product. Do not use it for any other
purpose.
4.
Continue to squeeze the start/stop lever
towards the upper handle and release the lock-
off button (Q).
5.
Lower the lawnmower to its proper operating
position and commence mowing.
•
NOTE - There are two start/stop levers
fitted. Either one can be used for starting
the lawnmower.
To Stop your Lawnmower
1.
Release the pressure on the Start/Stop lever.
Advertisement
Table of Contents
