Broan 103023 Instructions Manual page 3

INSTALL LINER
6. Fasten the two, adjustable front liners to hood with eight (8)
screws provided. Use a
and fasten them securely where they overlap.
MOUNT HOOD
7. Secure hood to wall, soffit or cabinets as appropriate.
8. Reach up through duct opening and connect power cord to
blower housing.
9. Slide damper assembly up into ductwork and refasten to blower
housing (using the two (2) screws removed in Step 3). Reinstall
blower assembly and plug it in.
(continued)
#8 x ½
7 / " dia. drill bit to drill through liners
64
POWER
CORD
MOUNT HOOD
NOTE:
Lamp Receptacles are
toward
REAR of hood.
10. Plug in control unit and fasten to hood as shown.
DUCT
OPENING
NOTE:
Filter Tabs
are toward
REAR of hood.
11. Install aluminum filter. Rotate two (2) retaining clips (on the
hood liner) to hold filter in place.
12. Install an F20T12 fluorescent tube (not supplied).
3
(continued)