Table of Contents
Advertisement
Hardware Setup
14
Connectors
Attach the mainboard to case devices, or an external battery, via
connectors on the mainboard. Refer to Figure 1-1 for connector locations
and connector pin positions.
ATX PW — ATX Power Supply Connectors
The motherboard provides an ATX power supply connector. It is a
twenty-pin male header connector. Plug the connector from the power
directly onto the board connector while making sure the pin1 is in its
position. You can only use either AT or ATX power.
11
20
JP9/JP50 – ATX Power Supply On/Off Switch Connectors
Due to that the ATX power supplies do not have an On/Off switch,
attach this 2-pin switch from the PC case for turning on or off your
power supply. There are two different types of On/Off switch connectors
in this motherboard: latch type (JP9) and momentary type (JP50). Latch
type is the traditional AT type of On/Off switch and momentary type is a
non-latch (one-touch) type of On/Off switch. You need to choose one or
the other type of these two switches depending on the PC case that you
have. Notice that you have to unplug the ATX power supply connector
before either installing or removing any add-on cards when you use the
momentary type of the On/Off switch.
J28, J29 – COM1/COM2 Connectors
Attach COM1/COM2 device cable to these connectors.
Advertisement
Table of Contents
