Table of Contents
Advertisement
4. Prior to placing the mounting frame into the
wall, pull a sufficient length of the Cat5 cable
and its attached RJ-45 connector through the
opening in the top of the mounting frame, as
shown in figure 4.
5. The retainer and bezel are pre-assembled
with internal packaging materials.
Disassemble by removing the four screws.
Discard the foam block and card insert.
6. Insert the KP-iOS mounting frame into the
opening in the wall.
Note: The Roto-Lock system can accommo-
date wall thickness of 3/8" to 3/4" and can
be extended to 1 1/4" with the removal of
the toggle caps.
7. Hand-tighten the four Roto-Lock screws on the
KP-iOS mounting frame as shown in Figure 5.
The Roto-Lock clamps will automatically
rotate into position behind the wall and
begin clamping the mount.
- Note: When you notice resistance on the
four screws, the KP-iOS has been clamped
successfully.
- ImportaNt: Never over-tighten the
Roto-Lock screws.
8. If there is a wall stud up against one side of
the utility box that prevents one Roto-Lock
clamp from operating, secure the box by
hand-driving a 1½" #6 drywall screw (not
provided) through the hole on that side of
the chassis and into the wall stud.
- ImportaNt: Do not over-tighten the
drywall screw.
6
Figure 4: Mounting Cradle Installation
Figure 5: Roto-Lock Screw Locations
KP-iOS
Advertisement
Table of Contents
