Avocent CPS810 Installer/User Manual page 42

42
CPS 810/1610 Installer/User Guide
setting of that parameter remains in effect. Multiple keyword parameters may
be specified on a single command.
This command allows the serial port settings (BAUD, SIZE, STOP, PARITY,
FLOW and TIMEOUT) for a specific port to be set. These are the settings that
will be used for the serial port. Upon successful completion of this command,
the new serial port settings for the port will be stored in the CPS Configuration
Database and will become effective immediately.
The following values must be set correctly or you will be unable to com-
municate with the attached serial device.
BAUD
Specify the baud rate for the attached device. Only those baud rates listed are
supported by the CPS.
SIZE
Specify the number of data bits per character for the attached device.
PARITY
Specify the parity for the attached device. Acceptable values are:
None no parity
Even even parity
Odd odd parity
Mark mark parity
Space space parity
STOP
Specify the number of stop bits for each serial character.
FLOW
Specify the flow control setting for the attached device.
XONXOF Software XON/XOFF flow control
RTSCTS Hardware RTS/CTS flow control
DTRDCD Hardware DTR/DCD flow control