Limited Warranty - AntennaTek Signal commander II Mod 3000 Owner's Manual

Step 8: Place the power supply(s) inside the elec-
trical box(s) and mount flush with 2# 6x3/4" flat
head screws. Attach the coaxial cable(s) to the
front of the power supply(s) and connect to the
television set(s).
SECTION II
Problem
LED on power supply does not
light up
Picture not clear
Note: Signals may be
interfered with if the an-
tenna is too close to ob-
structions such as build-
ings or trees.
SECTION III WARRANTY
AntennaTek, Inc. warrants this Signal Commander antenna, against any defects in material or workmanship for
one year from the date of purchase. AntennaTek, Inc., at its option, will repair or replace the defective product,
at no charge to you, provided that AntennaTek receives notice of a defect within one year from the original
purchase.
Promptly notify the seller, or alternately AntennaTek, of any claim hereunder. Provide proof of purchase to qualify
for credits under provisions of coverage. Obtain Authorization to Return from AntennaTek and return the product
to: AntennaTek, Inc., 425 S. Bowen St., Suite 4, Longmont, CO 80501, Phone 303-772-9591.
This warranty does not cover: any expenses for removal, travel, shipping, installation of the product, damage due
to misuse, improper installation, severe weather conditions, or other occurrences over which AntennaTek has no
control.
ALL OTHER WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED TO ONE YEAR FROM THE DATE OF PURCHASE.
LIABILITY FOR INDIRECT, SPECIAL OR CONSEQUENTIAL DAMAGES FOR ANY INCIDENTAL EXPENSES,
UNDER ANY AND ALL WARRANTIES IS EXCLUDED.
Some states do not allow limitation on how long an implied warranty lasts, or do not allow the exclusion or limitation
of incidental or consequential damages, so the above limitations may not apply to you.
This warranty gives you specific legal rights. You may also have other rights which vary from state to state.
4
TROUBLESHOOTING
Cause
Switch off
DC power
Coax cable shorted
Television
Wiring
Antenna cables
Power supply
Vehicle location

LIMITED WARRANTY

Step 9: Turn the switch ON on the main power supply.
Tune the TV receiver to the nearest TV station. Turn the
switch on the power supply OFF, the picture on TV
receiver should be degraded. This indicates that the
antenna is working properly.
Action
Turn switch ON
Check 12 V DC supply, & polarity
Replace coaxial cable
The power supply is equipped with a current
limiting device, which will shut off the power if
there is a short on the coaxial cable or the an-
tenna.
Tune in or change station
See installation steps 6-8
Coax cable going to antenna head should have
12V DC, between center conductor and outside
shield.
Switch ON (or OFF if you are too close to TV
transmitter)
Move vehicle