Summary of Contents for AntennaTek Signal commander II Mod 3000
- Page 1 OWNER'S MANUAL THIS MANUAL CONTAINS MOD 3000 INSTRUCTIONS FOR: - INSTALLATION - TROUBLESHOOTING - WARRANTY AntennaTek, Inc. 425 S. Bowen St., Suite 4 Longmont, CO 80501 (303)772-9591 FAX (303) 774-9533 www.antennatek.com Form: manv1...
- Page 2 Clamp bracket 062208 Pantera Sales (800) 456-0123 Power Supply 065840 AntennaTek (888) 349-8303 1. Installation Planning Follow the instructions in this manual in conjuction Power supplies should not be connected to existing with the RV manufacture's recommendations to lo- circuits with fans or motors as this may cause interfer-...
- Page 3 12 Volt receptacle. Maximum current rating of this receptacle is: 7.5 Amps at 12 Volt DC. Warning: Use of this power supply with any product other than AntennaTek amplified RV antenna could result in fire or other damage.
-
Page 4: Limited Warranty
AntennaTek, Inc. warrants this Signal Commander antenna, against any defects in material or workmanship for one year from the date of purchase. AntennaTek, Inc., at its option, will repair or replace the defective product, at no charge to you, provided that AntennaTek receives notice of a defect within one year from the original purchase.
Need help?
Do you have a question about the Signal commander II Mod 3000 and is the answer not in the manual?
Questions and answers
I g et no reception for tv
There may be no TV reception with the AntennaTek Mod 3000 due to the following possible causes:
1. The power supply switch is off — turn the switch ON.
2. There is no 12V DC power or incorrect polarity — check the 12V DC supply and its polarity.
3. The coaxial cable is shorted — replace the coaxial cable.
These issues prevent the antenna from functioning properly.
This answer is automatically generated