Secure Computing SnapGear Application Note page 17

Figure 13: Tunnel status:
Down example
86-0948364-A
7 Click the Enable this tunnel check box.
8 Enter
The remote party's IP address
end SnapGear. Use IP addresses specific to your networks. Examples
shown are for demo purposes only, and not part of a public test network.
9 Click the
Predefined
10 Select
Access all networks (default gateway)
11 Click the
Predefined
12 Select
Access all networks (default gateway)
list.
13 Enter a
Local Endpoint ID
uniquename@yourcompany.com
14 Enter a
Remote Endpoint ID
15 Enter a Preshared Secret of at least 21 characters that will be used in both
endpoint configurations. Keep this preshared secret confidential.
16 Click
.
Finish
Unless both VPN endpoints are configured, and have Internet access, the
VPN connection status in the Tunnel List will display a status of
Figure 13). If both endpoints are configured with reciprocal settings, the sta-
tus quickly transitions from
and then to Running
The VPN Quick Setup works best when the principle of reciprocal settings
is understood.
In Figure 14, the
pany.com.
Using the SnapGear VPN solution
using the Internet IP address of the far
button next to the Local Network field.
button across from the Remote Network field.
for this SnapGear using the format
.
using the same format.
Negotiating Phase 1
.
Local Endpoint ID
Setting up SnapGear for VoIP
from the Local Network list.
from the Remote Network
Down
to Negotiating Phase 2
is Branch27@yourcom-
(see
17