CD Changer Installation
7
26. Remove electrical connector (1) from lamp
module.
27. Carefully unthread manual override cable
from plastic loop (2).
28. Remove 2 upper T20 mounting screws (3).
Remove 2 rubber caps (4), then remove 2
lower T20 mounting screws (5).
29. Carefully pull back on Right panel and
maneuver the ABS storage unit out of the
vehicle. Be sure to disconnect lamp module
connectors.
30. Install right (1) and left (2) mounting brackets
using 4 M6x10 bolts (3&4) provided in
hardware kit.
31. Install 2 mounting bushings (1) as indicated
using 2 M4x10 screws (2) provided in kit.
32. Mount RH Bracket (3) as indicated using 2
M4x6 screws (4) provided in kit.
33. Insert 2 M5 Clip Nuts (2) as indicated.
34. Locate CD Changer Power and Audio leads
(1). Connect CD Changer Power and Audio
leads to CD Changer.