Installing centre trim
panel
Slip the centre trim panel un-
derneath the left and right side
panels at position 2 and then
seat it in guides 3 on left and
right.
Install four screws 1 on left and
right.
Install the seat (
58).
Removing battery
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
Switch off the ignition.
Remove the centre trim panel
(
116).
Disconnection in the wrong
sequence increases the risk
of short-circuits.
Always proceed in the correct
sequence.
Disconnect negative lead 1
first.
Then disconnect positive
lead 2.
Remove screw 3 and remove
the battery holder.
Lift the battery up and out;
work it slightly back and forth
if it is difficult to remove.
8
117
z