Vivitar ECam User Manual page 3

shutter button to take a picture. ECam will beep once to tell
you that the picture was taken. If ECam makes three low-
beeps, it is telling you that it was not ready to take a picture.
Try again.
Step 3: Connect ECam to your Computer --
•
Plug the large end of the cable that comes with ECam into a
9-pin port on the back of your computer.
•
Plug the small end of the ECam cable into the data port on
ECam
Step 4: Install the Software --
•
Install the Live Pix Looney Tunes software. (You only need
to do this once.) Insert the CD-ROM into your CD drive. It
should run automatically. Follow the screen messages to
finish the installation. If it does not run automatically see
detailed instructions. Don't forget to run the LivePix tutorial!
Step 5: Download your Pictures --
•
Start Live Pix Looney Tunes software. Click on the small
Ecam icon to download your pictures into the Looney Tunes
Software. You are now ready to insert your pictures into
any one of the many Looney Tune project templates. Have
fun!
3