Table of Contents
Advertisement
Section 1 - ECAM Quick Installation Guide
Follow the these steps to get ECam working for you -
Step 1: Install the Battery --
•
ECam uses a standard 9-volt DC battery. When Ecam is
put into its package there is a piece of tape over the two
battery terminals. Remove this tape.
•
Open the battery compartment. Use your thumb to slide the
battery door open. After you have removed the tape from
the
battery
compartment. There is a decal inside that shows the proper
way to place the battery. (The round battery terminal faces
down.) Once the battery is in place, replace the cover and
installation is complete!
Step 2: Turn on ECam and Take a Picture --
•
Slide the power switch to the right. ECam will beep twice to
tell you that it is OK and ready to take a picture.
•
Look at your subject through the view window and press the
terminals,
insert
2
the
battery
into
the
Advertisement
Table of Contents
