Getting Started; Charging Station - Russell Hobbs RHSV1B Instructions & Warranty

Congratulations on the purchase of your Russell Hobbs Cyclonic Stick Vacuum Cleaner.
Each unit is manufactured to ensure safety and reliability. Before using this appliance for
Pass it on if you pass on the appliance.

GETTING STARTED

Ensure you remove all parts from the packaging.
- Integrated crevice tool

CHARGING STATION

station must be located within approximately 1.8 metres of a wall power outlet.
FLOOR MOUNTING
Assemble the charging station by pushing the leg down into the foot until it locks into place.
WALL MOUNTING
Use the leg without the foot attached. Position the charging
distance of 80mm between the bottom of the leg and the
surface below to allow room for the motorised floor tool to
rest correctly. Mark the hole positions on the wall using the
charging station leg as a template.
the screw heads protruding 2 - 3mm from the wall.
Fit the charging station leg onto the screws in the wall.
CONNECTING THE AC ADAPTOR/CHARGER
the side of the charging station leg. Plug the AC adaptor/
charger into the wall power outlet. Switch on the wall
power outlet.
6
W A L L
80mm