How To Use The Stand - scope LSU VL-7EX II User Manual

If you have the "Old" SOAR, press the ERASE button, located on the
•
underside of the scope. Pressing the ON button will allow you to go
back to the previous light setting.
erases any images previously taken with the SOAR.

How to Use the Stand

The stand that comes with the Scope-On-A-Rope kit comes in handy when using the 1X lens,
using the 30X with the contact tip removed, or in any situation where you might want to use the
scope hands-free. Some people find that it is difficult to hold and focus the 200X lens, so
securing the scope in its stand can aid in obtaining well-focused images.
To put the scope in the stand, first remove the lens from the scope. This will give you greater
freedom of movement. Next, locate the metal screw plate on the underside of the scope. If your
scope does not have a screw plate, check your kit contents (a screw plate is included in all
Scope-On-A-Rope education kits). There are two holes on the scope body used to attach the
screw plate with two smaller screws.
Screw plate
Once the screw plate is on the scope, hold it up to the screw on the stand. Turn the screw
clockwise to secure it to the scope. Make sure to screw it on tightly so that the scope doesn't
wiggle around.
Spread the legs of the stand to give you maximum stability. Once the scope is secure in the
stand, attach the lens of your choice. You can use the stand in a variety of positions, and it can
be extended to give greater distance from the object you wish to view. It can also be twisted at
an angle for viewing the sides of objects.
From left to right: 1X close to object, 1X far from object, 200x viewing slide, 30x viewing side of rock.
Handheld Microscope Users Guide
Note: the ERASE button also
Attaching scope to stand
11