Assembly & Set-Up; Contents Of Carton - Cub Cadet 552 Operator's Manual

Assembly & Set-Up

Contents of Carton

• One Edger
• One Engine Operator's Manual
NOTE: This machine is shipped WITHOUT GASOLINE or OIL. After
setting up the edger, service the engine with gasoline and oil as
instructed in the separate Engine Operator's Manual packed with
your machine.
NOTE: Reference to right or left hand side of the edger is
observed from the operating position.
Assembly
Handle
Remove and discard any packaging cardboard that may be
present between the upper handle and the lower handle.
1. Pivot the upper handle upward until it snaps into place. See
Figure 3-1.
2
Figure 3-1
2. Tighten the hand knobs, which are located on both the left
and right sides of the handle.
• One Edger Operator's Manual
• One Trenching Blade Kit
1
• One Bottle Engine Oil
• One Wing Knob and Rope Guide
Control Cable Z-Fitting
Unwrap the control cable from the engine and route it under the
lower handle.
1. Hook the Z end of the brake cable into the control from the
outside to inside. See Figure 3-2.
Upper
Blade Control
Handle
Figure 3-2
3
Z-Fitting
7