English - Indesit HIP 9 P IX AUS Instructions For Use Manual

English

Wear gloves when carrying out installation and maintenance
operations.
GENERAL SAFETY
The minimum distance between the cook top and hood must
!
be 65 cm. If the hob installation instructions specify a greater
distance, it must be taken into account.
Do not flambé near the hood.
!
! If frying, be extremely careful with the superheated oils and
grease which may burst into flames.
Do not use open electric grilles.
!
! Do not position weights on the hood.
! Do not allow children or incapable persons to use the hood.
! During cooking accessible parts may become very hot!
! The hood is intended for installation above domestic hobs.
ELECTRICAL CONNECTION
! Arrange the electrical power supply within the decorative flue
dimensions. If your hood is provided with a power cable and
plug, position it so that the plug is easily accessible.
! The hood must be connected by plugging it into a power
socket. In the case of a direct electrical connection, interpose a
bipolar switch with a contact opening of at least 3 mm.
! Check that the voltage values correspond to those indicated on
the technical data plate inside the hood.
! Connection to earth ?
Connect to earth since they are in insulation class 1.
The power socket must be connected to earth.
AIR VENT
(for ducting versions)
! Prepare the hole and the air vent duct (150 mm diameter).
! Use a duct of the minimum indispensible length.
! Use a duct with as few elbows as possible (maximum elbow
angle: 90°).
! Avoid drastic changes in the duct cross-section.
! Use a duct with an as smooth as possible inside.
! The duct must be made of certified material.
! Do not connect the hood to smoke exhaust ducts for the
products of combustion (boilers, fireplaces, stoves, etc).
! For the air vents comply with the provisions laid down by the
competent authorities.
In addition, the air must not be evacuated through a hole in the
wall unless specifically intended for this purpose.
! Fit air intakes in the room to prevent the hood from creating a
negative pressure in the room (which must not exceed 0.04
mbar); if the hood is used at the same time as non-electrical
equipment (gas-, oil- and charcoal-fired stoves, etc.) the
exhaust gas may be sucked in by the heat source.
FILTERING OR DUCTING VERSION ?
The hood may be in filtering or in ducting version. Decide from the
outset which type is to be installed.
For better efficiency, we recommend installing the hood in the
ducting version (if possible).
Ducting version (A)
The hood purifies the air and evacuates it to the outside through an
exhaust duct (diameter 150 mm).
Filtering version (B)
The hood purifies the air and recycles the clean air back into the
room. For this version, the following are required: 1 air baffle, 1
reducer, 1 charcoal filter.
The upper flue air evacuation slots must be positioned at the top.
12
CONTROLS
A - Light button
Turns the lights on/off.
B - Motor ON/OFF button
Activates/deactivates the motor.
The motor is activated at first speed.
C - Second speed button
Activates the motor at second speed
D - Third speed button
Activates the motor at third speed
E - Motor operation light
A B
MAINTENANCE
! Before cleaning or maintenance cut the power.
Cleaning the hood
WHEN TO CLEAN IT: clean it at least every 2 months to prevent
the risk of fire.
EXTERNAL CLEANING: use a cloth moistened in lukewarm water
and neutral detergent (for painted hoods); use specific products for
steel, copper or brass hoods.
INTERNAL CLEANING: use a cloth (or brush) soaked in denatured
ethyl alcohol.
WHAT NOT TO DO: do not use abrasive or corrosive products
(e.g. metal sponges, brushes, too hard brushes, very aggressive
detergents, etc.)
Cleaning the grease filters
WHEN TO CLEAN IT: clean it at least every 2 months to prevent
the risk of fire.
HOW TO REMOVE THE FILTERS: push the catch near the handle
towards the rear of the hood and pull the filter downwards
HOW TO CLEAN THE FILTERS: hand wash or in the dishwasher
using a neutral detergent. If washing in the dishwasher, possible
discoloration of the filters does not in any way compromise their
functioning.
C D E