Rear Combination Lamps - Chevrolet Metro 2000 Owner's Manual

To remove the front turn signal, parking or
sidemarker lamps:
1. Open the hood.
2. Using a Phillips screwdriver, remove the headlamp
assembly mounting screws.
3. Pull the headlamp straight out from the vehicle.
4. Turn the appropriate socket counterclockwise and
pull the socket out.
5. Pull the old bulb straight up to remove it.
6. Reverse the steps with the new bulb.
Center High-Mounted Stoplamp
(2-Door Model)
1. Remove the two mounting screws located inside the
hatchback door and then the lamp assembly from the
hatchback door.
2. Remove the bulb from the socket.
3. Replace the bulb with a new one and then use the
two mounting screws to secure the lamp assembly
into place.
6-36
Center High-Mounted Stoplamp
(4-Door Model)
1. Open the rear compartment lid.
2. Remove the bulb socket from the underside of the
rear seat to rear window panel.
3. Twist the bulb to the right and pull it straight out.
4. Replace the bulb then snap and turn the bulb socket
into the lamp housing.

Rear Combination Lamps

To remove the rear combination bulbs:
1. Remove the two screws from the combination lamps
on the outside of the vehicle.
-
2. On 4 door models, pull back the cover on the inside
of the trunk and use a 10 mm wrench to remove
the nut.
3. Pull the assembly out far enough to reach the
bulb socket.