Changing The Filters - Filter Queen Majestic Manual

Changing The Filters

A.
a. Changing The Filter Cones
For best performance, replace Cones as recommended by manufacturer:
t BioCone Filter – every month
™
t MEDIpure – every 6 months
®
t Flat Disc Filter – every 6 months
WARNING – DO NOT operate your power unit without Genuine
FILTERQUEEN
BEWARE OF IMITATIONS: Use only Genuine FILTERQUEEN
Imitations can result in poor performance and cause damage to your unit.
1. Unplug power cord from wall and detach hose from power unit.
2. Release side clamps and remove power unit from dirt container.
3. Remove MEDIpure
4. Empty contents of dirt container into a large, open garbage bag. Allow contents of container
to fall including used BioCone
remove all dust and/or any odors.
5. Open a new BioCone
of the dirt container. Be sure all edges of the Cone are even with the gasket of the dirt
container.
6. Place the MEDIPure
7. Replace power unit and lock side clamps in place. Be sure all three tabs of the BioCone
Filter are visible outside the power unit.
B. Changing The Flat Disc Filter
1. Unplug power cord from wall and detach hose power unit.
2. Release side clamps and remove power unit from dirt container.
3. Remove the Cone guard. Next, remove the Flat Disc Filter by pulling back the plastic retainer
ring with your finger and lifting it out.
4. Replace Flat Disc Filter. Place the filter over the center section of the screen. Replace the retainer
ring by squeezing ring. Make sure ring fits snugly under the three tabs of the plastic screen.
Replace the Cone guard. Be sure the outer edge of the Cone is seated on the rubber lip around
the circumference of the power unit and replace screw.
A.
® Filter Cones in place.
Cone and set aside or discard when installing a new BioCone
®
Filter. Dirt container may be washed and thoroughly dried to
™
Filter. Insert point of Cone into Filter Cone locator in the bottom
™
Cone inside the BioCone
®
12
B.
Filter.
™
B.
® Filter Cones.
Filter.
™
™