Panasonic sv-3200 Operating Instructions Manual page 13

PLAY
STOP
Shultle search dial
-
o o
REW/REV FF/CUE REC PAUSE
I -
I
To Begin Recording or Playback - -- - - - - - - - - - - - - - - ­
Ie
Press the play button. Press the rec button and then press the play
19
The play indicalor illuminales, and play begins. button.
or
The rec and play indicators illuminate, and recording starts.
is
To briefly interrupt Recording or Playback - - - - - - - - - - - - - ­
Press the pause button.
Press the play button to resume play.
The unit switches to the pause mode and the pause indicalor
illuminates.
To Stop Recording or Playback
----~------------­
Press the stop button. If the unit is not going to be used for extended periods,
Recording or playback stops. rewind the cassette tape back to the beginning ,
In the case of programmed play, the memory is also cleared .
remove it and turn off the power.
Rewind Play, Fast-Forward Play (During playback) - - - - - - - - - ­
When the fast-forward button or rewind button is
kept depressed:
Advances or reverses the tape during playback at about 3 times
normal speed (does not operate during recording) .
Rewind, Fast-Forward (During stop mode) - - - - ---'--- - - - - - ­
When pressed once, the tape advances/reverses at about 250 times
normal speed ; when pressed twice , the tape advances/reverses at
about 400 times normal speed. Each subsequent press causes
alternate switching between the 250 times and 400 times speeds .
When operating the " Cue" or " Review", the monitor sounds will
have some noise caused by the head crossing over the recorded
Irack on the slant.
Reduce Ihe volume of the amplifier
10
optimum level. (Take special
care during playback with digital output signals .)
This unit is also equipped with a shuttle-search function ; the
shuttle dial can thu s be used 10 perform rewind play and
fast-forward play . For details, see page 32.
-13­
Learning search function
This unit comes with a learning function which memorizes
once-passed program positions either by normal playback or
by fast forwarding or rewinding at 250 times normal tape
speed.
Therefore, when a once-passed program number has been
assigned, the function will automatically search a program at
up to 400 times normal tape speed .
(If , however, the program to be searched is located close to
the present tape position, the tape will not be accelerated up
to 400 times normat tape speed .)