Triplex T3200-DVR User Manual

Triplex standalone dvr 4/8-channel

Advertisement

Quick Links

Digital Surveillance System
User's Manual
(V1.1)
Precautions for safety...............................................................................2
Package Content.......................................................................................2
DVR Introduction.......................................................................................2
1.
Product Overview.........................................................................3
2.
Front Panel.................................................................................3
3.
Rear Panel.................................................................................4
4.
IR Remote Controller(Optional).......................................................4
System Setup and Installation.....................................................................5
1
Hard Disk Drive Installation.............................................................5
1.1
1.2
2
Video Format Selection..................................................................5
3
Monitor Connection........................................................................6
4
Camera Connection.......................................................................6
5
USB Connection...........................................................................6
6
Sensor Installation.........................................................................6
7
Alarm Installation...........................................................................7
8
Network Connection......................................................................7
Getting Start Operation..............................................................................7
1. Start Up the DVR System................................................................7
2. Main Screen.................................................................................8
3. Set Up.........................................................................................8
3.1
3.2
3.3
3.4
3.5
3.6
3.7
9KDE28MNL00EN01
3.8

Table of Contents

Install the internal hard disk drive.............................................5
Log In.................................................................................8
Camera Setting.....................................................................8
Record Setting.....................................................................9
Sensor Setting.....................................................................9
Motion Detection Setting.......................................................10
Screen Adjustment...............................................................10
Audio Setting......................................................................11
System Setting....................................................................11

Advertisement

Table of Contents
loading

Summary of Contents for Triplex T3200-DVR

  • Page 1: Table Of Contents

    Digital Surveillance System DVR Introduction…………………………………………………………………………...2 Product Overview……………………………………………………………….3 Front Panel………………………………………………………………………3 Rear Panel………………………………………………………………………4 Triplex Standalone DVR IR Remote Controller(Optional)……………………………………………….4 System Setup and Installation…………………………………………………………...5 Hard Disk Drive Installation…………………………………………………….5 Install the internal hard disk drive………………………………………5 Install DVD±RW or mobile rack for removable hard disk drive…...…5 Video Format Selection…………………………………………………………5...
  • Page 2: Precautions For Safety

    Back up via internal CD-RW or DVD±RW Drive……………………..15 Player and Remote Monitoring…………………………………………………………15 Package Contents Triplex Viewer – Player………………………………………………………..16 1. Triplex Standalone DVR Series DVR Main Unit Main function menu& Display Screen………………………………..16 2. Power Adaptor & AC Power Cord Play back with saved video data………………………………………17 3.
  • Page 3: Dvr Introduction

    ► PLAY Playback / Enter time search for video playback 7. Friendly User Interface ▌▌ PAUSE Pause playback Triplex Standalone DVR series consist 2 product lines of 4 and 8 channels shown as ◄◄ REW Backward playback below: > RIGHT Move RIGHT through menu list Λ...
  • Page 4: Triplex Standalone Dvr

    Move DOWN through menu list SELECT / ENTER To change values on menu. Red LED Light Shows HDD is recording or reading ▬ 3 Rear Panel Triplex Standalone DVR 4/8-channel Function Button/Name Function AC-DC Power Adapter Jack 1~10 (channels) Channel selector...
  • Page 5: System Setup And Installation

    System Setup and Installation The total maximal capacity of HDD for Triplex Standalone DVR series is 1TB for 1 Hard Disc Drive Installation 4/8CH with 8MB buffer. 1.1 Install the internal hard disc drive 2 Video Format Selection (A) Make sure the DVR power is off before HDD...
  • Page 6: Camera Connection

    There are 4 channels for Triplex Standalone DVR-4CH, 8 channels for Triplex Standalone DVR-8CH.each camera has two wirings basically: BNC and Power. The DVR unit can be connected up to 4 sensors for Triplex Standalone DVR-4CH, 8 Connect the BNC cable to DVR’s “VIDEO IN” connector on rear panel for video sensors for 8CH;...
  • Page 7: Alarm Installation

    7 Alarm Installation Getting Start Operation 1 Start Up the DVR System The DVR has an internal switch for sounding alarm. The switch is normally open, but when the sensor is triggered, the alarm is activated as well. Connects the alarm signal lines to alarm switch terminal on rear panel and connect After the DVR unit and all the peripherals are properly installed, the DVR is ready to the alarm power lines to power source.
  • Page 8: Main Screen

    2 Main Screen 3 Set Up 3.1 Log In The configuration of DVR can be customized by adjusting the menu setting. Press the MENU button and password to enter setup menu. Password verification screen displays as bellow. The default password is “111111”. After entering menu list, use UP/Down and ENTER button on front panel or remote controller to change the settings.
  • Page 9: Record Setting

    Brightness/Contrast/Hue/Saturation: To adjust the image performance by setting Record Quality: Select the record quality as High, Normal or Low. brightness, contrast, hue and saturation adjustment. Event Rec Duration: Set the record duration from alarm was triggered in 5, 10, 15, Video Loss: Set the Video Loss Alarm as Intermittent or Continues;...
  • Page 10: Motion Detection Setting

    Sensor Type: Select DISABLE to deactivate sensor recording or choose the type of sensor as NORMAL-CLOSE or NORMAL-OPEN installed in DVR. In general, three common sensor types are available in home electronic store: (1) Normal-Close, (2) Normal-Open and (3) Normal-Close & Open. Below is the brief diagram about how each type of sensor is installed on DVR.
  • Page 11: Audio Setting

    3.7 Audio Setting Format HDD: If the hard disc drive was formatted, all the video data stored will be Change the recorded audio setting by adjusting setup in this item. deleted, the DVR system supports no restore option once the hard disc drive is formatted.
  • Page 12: Time Set

    Time Set: set the current date and time You need to use the network setting information above for real-time network viewing on PC using “Triplex Viewer” software for remote viewing through Ethernet Daylight Saving Time: Choose NO or YES Date Format: DVR offers two formats with YYYY/MM/DD and DD/MM/YYYY connection.
  • Page 13: Pan/Tilt/Zoom Device

    For STATIC IP, input your static IP, gateway, net mask and save it, restart the DVR, and DVR will auto connect to internet Baud rate: Setup the baud rate of camera from 1200 to 115200 Data Bit: Set the data bit 7 or 8 Parity Bit: set the parity bit in none, odd or even Stop Bit: set the stop bit in 1 or 2 For DHCP, Select DHCP and save it, restart the DVR and system will auto allot a IP...
  • Page 14: Firmware Upgrade

    3.9 Video Search In video search, user could playback the recorded video data by choosing date& time, use the SELECT button to adjust starting and ending date& time for playback. After time period was set, move the cursor to SEARCH and press ENTER button again to start playback from the date&...
  • Page 15: Playback

    DVD±RW drive (Optional) 4 Playback Notice: Triplex Standalone DVR supports all CD disc, DVD+R disc, for DVD+RW disc only the To playback, press PLAY button. A Time Search function will display on screen, on first writing, and not support for DVD-R and DVD-RW disc.
  • Page 16: Triplex Viewer - Player

    Convert the VVF video format to AVI for standard player like Windows Media Player. Play Reverse Close Close Triplex Viewer Show Time To display date& time on Triplex viewer screen when playback. Go one frame backward and PAUSE Always On Top Make the display screen on top. Pause...
  • Page 17: Play Back With Saved Video Data

    (c) Double click the “Triplex Viewer Setup” software to run the program. When the viewer screen comes out, use the right click of mouse to show the function menu and choose “Open File”. Note: For the instant playback, drag and drop the VVF file to Triplex Viewer window.
  • Page 18: Convert Video Format As Standard Avi Format

    1.3 Convert Video Format as standard AVI format (3) Choose the file which to be converted and click”Open“. Users can convert the backup VVF file into AVI format in order to view by the standard MPEG-4 player or other media player (ex: Windows Media Player). (1) Choose Export >...
  • Page 19: Triplex Viewer - Net Viewer

    2 Triplex Viewer - Net Viewer 2.2 Connect PC to DVR through local area network (network hub) Open Triplex Viewer and select “Net Viewer” option for remote monitoring, remote (1) In “Net Viewer” mode. Click “Connect” option controlling and recording either on PC or DVR.
  • Page 20: Connect Pc To Dvr Through Cross-Over Cable

    (2) And it needs to change the TCP/IP setting under Windows XP system shown as below. (3) Go to TCP/IP setting under Local Area Connection Properties of Windows XP system. (5) Click “OK” and run Triplex Viewer, click “Connet” under Net Viewer menu.
  • Page 21: Remote Monitoring Through Ie Browser

    Input DVR IP Address:192.168.1.100 to URL as http://192.168.1.100 (reference) (1) At first, a Installation of Active-X Control component is needed (A) Please insert the Triplex DVR CD into CD-ROM, also insert USB flash disc to PC for backup, then copy the file “VXVSETUP.EXE” to USB flash disc from the folder of Active-X Control\ Triplex-4 DVR or Triplex-8 DVR.
  • Page 22 If Triplex Viewer can’t show up, Please install this file to download “V After installation, the viewer windows will appear as below, please enter: XVSETUP.EXE” IP: 192.168.1.100 (for reference) DVR port: 8841 (for reference) Password: 111111 (the default password) then click “Connect”.
  • Page 23: Ddns Setup

    4 DDNS Setup (C) Enter the dynamic IP address detected by DynDNS (DynDNS will As the ISP cannot support static IP, we recommended using dynamic IP through auto-detect your dynamic IP address from your ISP) in “IP address”. Press DDNS. the button of “Save Changes”...
  • Page 24 4.2 Set up 2 DVR under the same router for DDNS (E) Then, enter the selection of NAT in router to set up the port of DVR1 & (1) First of all, connect these 2 DVR to the same router and we can name them as DVR2 to a designated IP of DVR in virtual server.
  • Page 25: Appendix A - Recommended Hdd

    Appendix A – Recommended HDD After finishing the setting, you may want test. The following example is for your reference under IE Browser. The connect screen of DVR1 (8841 port). The connect screen of DVR2 (8842 port). Refer to the following list for some recommended HDD to be used in DVR Manufacturer Model Name Interface...
  • Page 26: Appendix B - Record Time Table

    Appendix C – Camera Installation Guide Appendix B – HDD Record Time Table 1) Check all accessories 2) Lock Screws with camera stand Base on recording frame and quality, a reference list for record time table is as following table. The recording hours is based on 250GB HDD for 4-Channel Frame Per Second High...
  • Page 27: Appendix D -Mobile Phone Ap Installation Guide

    Appendix D –Mobile Phone AP Installation Guide Select “Connect” to link the Internet. JViewer is an application program for JAVA MIDP 2.0, data communication should set to Wi-Fi/WLAN, 3.5G/HSDPA, 3G as well. (1) Application program installation By "yes" to ignore the security warning (a) Via CD-ROM: message Copy JViewer.jad and JViwer.jar in...

Table of Contents