Frigidaire Room Air Conditioner Use And Care Manual page 8

Operating Instructions
Operating Instructions
(continued)
REMOTE SENSING FEATURE
(on some models):
G9 o
' \. A ^ '
s<
,i_v_S,
O O Q
o o o
FRIOIOAIRI1
cr- ^j
r
DO THIS:
PRESS REMOTE
" SENSING
START BUTTON
LIGHT pulsing (On & Off intermittently).
NOTE: Unit display shows the set temperature
NOTE: Remote display
is actual temperature
at remote control only
Note: This feature can be activated from the remote control ONLY, the unit must be in a cooling mode.
To activate the remote sensing feature, point the remote control towards the unit and press the remote sensing Start button. Next, use
the " A V " buttons to set the desired temperature at the remote. (Note that the set temperature will only be displayed on the unit
itself). The LIGHT on the unit control will pulse to Indicate it received the signal. The LIGHT on the remote control will pulse each time it
sends a signal. It will periodically send this signal until the feature is deactivated by pressing the remote sensing Stop button. If the unit
does not receive the remote sensing signal during any 3 minute Interval, the unit will beep to indicate the remote sensing mode has
ended. The display on the remote control Indicates the temperature at the remote ONLY.
NOTE: The Remote Sensing function is terminated either by using the Remote Sensing Stop button or the main ON/OFF button on the
unit.
HEATING FEATURE(on some models): YOU WILL SEE:
mode
DO THIS:
PRESS
MODE BUTTON
SELECT HEAT
■
htat
cool
tntrgysMtr
fmaiti
mode
filter
reset
A
V 1
Note: This feature can be used with any combination of FAN Speeds (Low speed only en 115V models), Timer, or Sleep Modes. When in
the "Heat" mode,the fan will run continuously while heat is needed. The temperature will automatically be maintained anywhere between
55 °F(13 °Q and 80 °F(27 °C) When the room set temperature is satisfied, the fan will cyde off and on to circulate and sample the room
air.
FAULT CODES:
If the display reads "HS", a sensor has
failed. Contact your Authorized Frigldaire
Service Center.
If the display reads "AS", a sensor has
failed. Contact your Authorized Frigidatre
Service Center.
If the display reads "ES", a sensor has
failed. Contact your Authorized Frigidaire
Service Center.
8
©2009 Electrolux Home Products, Inc. All rights reserved.