Grill Head Installation - Napoleon MIRAGE 485 Assembly And Operating Instructions Manual

6 x
N570-0073 (1/4-20 x 3/8")
9

Grill Head Installation

PROPANE ONLY - To avoid assembly difficulties, prior to mounting the grill
head, remove zip tie holding regulator up under control panel. This was installed
at the factory to protect the regulator hose during shipping and is no longer re-
quired. (Take care when removing the tie not to damage the hose). Ensure the
regulator drops into the small opening, between the tank heat shield and the right
side of the cabinet.
Lift grill head and place on assembled cart, lining up holes in top of side cart pan-
els with holes in bottom of base. Fasten from inside using (4)1/4-20 x 3/
8"screws, two per side. Install battery pack below vent slots on left hand panel
using magnet supplied with battery pack. Plug wire from LED (lights) located
underneath control panel into wire from battery pack. Install rotisserie mount
bracket to left side of barbecue as shown using (2) 1/4-20 x 3/8" screws.
TWO PEOPLE ARE REQUIRED
16
FOR THIS STEP