Alfa Romeo 33 Workshop Manual page 78

ber t'o the left $rut @ .
h. Swing the front cross member
i. Unscrew and remove the two screws
1 2 .
m. l!ower column lift and take the drive
1. ereliminary Operations
rear support and the engine front sup-
port are not respectively upwards and
longitudinally preloaded.
a. Raise the drive unit wi!h the column
PA327900883301
,
ENGINE MAIN MECHANICAL,,UNIT
1 Boit
2 Central support
b. With referdnce to figure at' page
01.6, rotate the front crossme,mber
ting position and fix it with bolt @ to
strut @ then fully tighten bolts @
and 0.
0
c. Tighten screws 4 fixing the engi-
ne front support.
d. Tighten !he foilowing components
Tightening torques
bar bïacket to body
Screws fixing stabiliting bar
l
Screws connecting semishaft
l
. differential shafts (in 'engine
33 + 36 N.m
e. With reference to following figure
remove lift and loosen lower b&t @
vant poitit fixing it to body and'tighten
g. Retighten lower nut @
1 Rear support of gearbox
2 Pin
3 Rear support securing screw
4 Bolt securing gearbox
rear support
h. Insert the side rod @ into support
on right side longitudinal member
1 Ri,ghl cylinder head
2 Right side longitudinal member
3 Support
4 Side rod (engine antishock bar)
5 Front screw
6 Rear screw
2. Reinstallation of reverse light table
and of exhaust pipe
a. Reconnect the reverse light table to
gearbox switch.
order with respect to removal,
verse
mainfolds and catalytic muffler.
October 1988